Today, the task of the spraying process continues to become more complex in order to fulfil the process, quality, ecological and economical demands.
For this purpose, Wollin continues to develop its PowerSpray systematically.
Increasingly efficient mold tempering, mold cooling and also the use of highly effective water-based release agents allow accurate spraying to form a thin, homogeneous release film. Furthermore, the mold tempering can be supported by the spraying process.
With the use of a mask spraying tool and thanks to the modular design of Wollin spray tools, the spray tool can be specifically adapted to the casting mold and the casting process.
- shorter cycle times
- high productivity and process reliability
- less compressed air consumption
- heating & cooling units more in less expensive cooling mode
- scrap reduction
- longer die service life
- short set-up times
- less use of release agents and waste water